Herunterladen Inhalt Inhalt Diese Seite drucken

Maintenance And Storage - Hecht 206 V Betriebsanleitung

Inhaltsverzeichnis

Werbung

control dial at 1-5 position - it depends on used
content - see table above.
7. Control of the spreading rate is determined by a
combination of the users walking speed, motor
speed, feed aperture opening and the material
to be spread. As there is no accurate method to
determine the correct setting for all spreading rates
and the different types of material being spread.
The user must determine through trial and error
the correct settings for the material being spread.
8. Check the instructions on the packaging
containing the material to be spread.
9. The table below is for reference only. The exact
amount you need to test in practice. Remember
that more fertilizer can damage grass. Always
proceed from lower to higher settings.
10. Push back the safety switch (fig. 8A) and press the
ON/OFF switch (fig. 8B).
11. The ON/OFF switch operates the feed aperture
opening and the spreading impeller at the same
time
12. Spread a small area first and adjust the settings if
necessary.
13. When in use the spreader should be held in one
hand with your arm by your side and held slightly
forward (fig. 9). There is no need to swing the
spreader from side to side.
14. To turn off the device release switch ON / OFF.
CS - BaTEriovÝ rUČNí roZMETaČ - NÁvoD K PoUŽiTí
BEZPEČNoSTNí PoKYNY
Nejprve si přečtěte návod k obsluze!
Přečtěte si veškeré pokyny, obsažené v tomto
návodu před zahájením provozu. Zvláštní pozornost
věnujte bezpečnostním instrukcím.
Tento přístroj je výhradně určen
- k použití odpovídajícímu popisům
a
bezpečnostním
uvedeným v tomto návodu k použití
- k aplikaci hnojiv, osiv a posypové soli
Jakékoli
jiné
použití
účelu. Použití neodpovídající určenému účelu má
za následek zánik záruky a odmítnutí jakékoliv
odpovědnosti ze strany výrobce. Uživatel ručí
za všechny škody způsobené třetím osobám
a jejich majetku. Neoprávněně provedené změny
upozorněním
neodpovídá
určenému

MaiNTENaNCE aND SToragE

• Never leave the fertilizer or salt in the container.
Remaining chemicals return into the original
packing and carefully close.
• Clean the impeller plate after each use. Fertilizer
stuck on the impeller blades will cause uneven
spreading.
• After each operation carefully wipe the spreader with
a damp cloth and remove all settled material. Do
not submerge any of the device parts in liquid. After
washing let properly dry out.
• Do not use cleaning agents or solvents; these may be
aggressive to the plastic parts in the appliance.
• When you are not using the equipment, keep it in a
dry place out of the reach of children.
• Always remove the batteries if the spreader is to be
stored for long periods.
• Dispose your device, accessories and packaging in
accordance with the requirements of environmental
protection into the recycling collection center
• Always dispose of batteries in accordance with
applicable legal regulations. Do not dispose of
batteries with the normal household waste.
na stroji vylučují ručení výrobce za škody, které
z toho vyplývají.
Dbejte prosím na to, že naše stroje nebyly podle
svého účelu určení konstruovány pro živnostenské,
řemeslnické
Nepřebíráme žádné ručení, pokud je stroj používán
v živnostenských, řemeslných nebo průmyslových
podnicích a při srovnatelných činnostech.
Nepřetěžujte stroj – používejte jej pouze
v rámci výkonů, pro které byl zkonstruován.
• Nedovolte nikomu provozovat rozmetač bez řádných
instrukcí.
• Zařízení nepoužívejte, pokud jsou v blízkosti lidé,
děti nebo domácí zvířata.
• Nedovolte dětem, aby si s rozmetačem hrály.
• Při manipulování nebo použití trávníkové nebo
zahradní chemie používejte ochranu očí a rukou a
6 / 11
DiSPoSaL
nebo
průmyslové
použití.

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis