mcgrey SUB 15A Bedienungsanleitung

Water warning:
• Do not expose the device to rain, use it near water or in damp or wet conditions on it containing liquids which might spill
into any openings. Never insert or remove an electric plug with wet hands.
If you notice any abnormality:
• If the power cord or plug becomes frayed or damaged, or if there is a sudden loss of sound during use of the device, or if
any unusual smells or smoke should appear to be caused by it, immediately turn off the power switch, disconnect the
electric plug from the outlet, and have the device inspected by qualified service personnel.
E
N
G
Power connection and wireing
L
I
Please connect the power cable to 110/220(230)V 50/60Hz power voltage. Make sure to set
S the power input selector to the available net voltage. Connect all input/output signals with
XLR and/or 6.35mm jack cabels.
H
Switch on net power after you finished all audio connections
Connectors and operator elements:
1 Volume control Line In (right channel)
2 Volume control Line In (left channel)
3 Volume control Line Out (right channel)
4 Volume control Line Out (left channel)
5 Crossover frequency control 40Hz .. 250Hz
6 Phase shift control
7 LED Power On
8 LED Clip
9 Net voltage selector 110/220(230)V
10 Power switch On/Off
11 Net cable power in
12/13 Line In (right/left channel) connect audio signal (e.g. mixer out) with
XLR-cable or 6.35mm jack cable
14/15 Line Out (right/left channel) connect external active device (Top Speaker,
power amplifier) with XLR-cable. Adjust crossover frequency (5) to set
SUB/Line Out range.
7
Bedienungsanleitung
Operators manual
00000026671
McGrey SUB 15A