Inhaltsverzeichnis
Werbung
• Ziehen Sie nach Einstellarbeiten alle Arretierungen wieder fest an und achten Sie regelmäßig auf einen
ausreichend festen Sitz des Arbeitsscheinwerfers.
• Zur Vermeidung von Brand- oder Personenschäden darf der Scheinwerfer nur mit der vorhandenen Schutzabdeckung
betrieben werden. Bitte ersetzen Sie umgehend eine gebrochene Scheibe.
Safety Notes and Using
Please note the following safety notes to avoid malfunctions, damage or physical injury:
• This manual belongs to the product. It contains important notes on operating the unit. Please pass it on along with
the unit if it is handed over to a third party!
• Dispose of the packaging materials carefully; the plastic bags may become a deadly toy for children.
• Keep the unit out of the reach of children. It is not a toy.
• Do not stare directly into the LEDs and do not direct the light beam towards people or animals.
• Do not use devices which can strongly focus light for viewing the light beam.
• Do not continue to use the unit if the unit is damaged. Repair work must be done by a qualified service technician.
• Disconnect the unit from the power mains if you don't use it or clean it (unplug, release fuse, etc.).
• Do not expose the unit to direct sunlight, humidity, dirt, high temperature, strong light or strong magnetic fields.
• Close proximity to strong transmitters may cause malfunctions of the motion detector. Strong transmitters can
be e.g. amateur radio operators in your neighbourhood or transmitting masts for mobile telephone systems or
broadcasting stations. In this case, it may happen that the motion detector switches on casually, without
detecting an animal or a person near by the motion detector.
• Do not expose the LED spotlight to excessive temperatures, strong magnetic fields or to strong vibrations.
• Do not use the product in rooms or in poor ambient conditions where flammable gases, vapours or explosive
dust may be present or are present! There is a risk of explosion!
• Do not immerse any components of the LED spotlight in liquids of any kind.
• Position the power cord securely so it cannot become a tripping hazard. Do not bend the power cord too much
and do not jam the cord or pull it around edges.
• Immediately replace a broken glass of the spotlight.
• Allow at least 1 m illuminating distance to other objects.
• Mount the lamp only on normally flammable or flame resistant surfaces and take care that the product may not be
exposed to extreme temperatures, strong vibrations or strong mechanical stress.
• Never cover the product when it is in use.
• The product is not intended for operation in altitudes of over 2000 meters.
• Do not disassemble the unit or attempt to modify or repair it yourself. It does not contain parts serviceable by you.In
case of questions or problems, turn to our customer service.
• It is not allowed to use the LED work light in vehicles in road traffic. If the work light is used in road traffic the
operating license will expire. Only qualified personnel are allowed to work on electrical systems in vehicles. For
installing the LED work light observe the regulations and safety instructions.
• If you have to drill holes into the vehicle structure for mounting the LED work light, make sure not to damage the
surface of the vehicle (e.g. corrosion). Make sure not to damage cables or supporting parts.
• Tighten all screws after adjustment and frequently inspect the unit to make sure that it is securely attached.
• To avoid danger of fire and personal injuries, operate the work light only with the protective cover in place
and replace a broken cover immediately.
• National and international safety, health and occupational safety regulations must be observed and complied with.
Werbung
Inhaltsverzeichnis
