Skan Holz Varberg 3 Montageanleitung Seite 5

Vorschau ausblenden Andere Handbücher für Varberg 3:

Verfügbare Sprachen

Varberg 3 570 x 525cm

Important informations

We are pleased that you have chosen a product of SKAN HOLZ.

Please check the construction set for completeness using the position list in good time before starting con-

struction or commissioning your construction team. If individual parts are defective or missing, we will deliver

these as quickly as possible. However, we cannot refund the costs for any resulting construction delays to a

construction company.

Please understand that we cannot assume any guarantee for the following defects:

- incorrect storage before assembly

- incorrect anchoring with the ground or inadequate foundation (foundation according to statics)

- damage due to erection errors, e. g. the house is not level or not right-angled

- damage through a higher level of snow burden than statically envisaged. Recommendation: lad relief of

the roof by removing the snow layer

- storm damage (insurance cases) or violent destruction

- damage through any alteration to the design by the client

- natural formation of cracks, branch holes, twisting, decolouration or similar modification (natural

process; has no influence on the statics)

Storage information until construction :

- store pallet on a level and dry surface. Tip: do not remove the foil and plastic straps until just before

assembly!

- Protect from exposure to sunlight and the influences of weather ; wood can warp drastically in a loose

condition!

Maintenance tips:

The wood is untreated. Accordingly, regular, protective coating is absolutely necessary!

Please observe the attached information sheet "Care instructions/Colour treatment".

To the drawings:

Foundation according (to the structural calculations, not included in the scope of delivery):

concrete C25/30, strip foundation: w/h = 30/90cm, each 2 Ø 12 top and bottom, bow Ø 6, e < 20cm.

Bottom panel: t=14cm,Q188A, top and bottom throughout. Anchoring of the floor beams on the strip

foundation using bolts M12, e < 60cm (by customer).

Given that the roof is constantly exposed to the weather, a covering with only one layer of roofing pa-

per will not be enough over the long-term. An additional covering with bitumen shingles, alternatively

with a material of at least equivalent quality, must follow.

247172

(unbehandelt)

247172-13 (schiefergrau)

247172-15 (schwedenrot)