KAPS Flash Bedienungsanleitung Seite 22

To adjust the suspension
1.) The City Driver comes with its suspension set to hard.
2.) To set the suspension to soft, turn the lever provided beneath each spring
adjacent to the wheel - see Figure #13.
3.) pram Flash: adjustable suspension only on the rear axle
Mesh lining
1.) To convert the hood to mesh lining, remove the hood by undoing the zip
fastener.
2.) The zip fastener extends across the full hood.
To convert the pushchair to a stroller
1.) Remove the soft carrier bag.
2.) Remove the lying surface extension.
3.) Attach the retaining bar to the frame using the two snap fasteners - see
Figure # 8.
4.) Now, use the snap fasteners to fasten the retaining belt on the retaining bar.
To adjust the footrest
1.) The footrest can be adjusted by means of the snap fasteners provided on
either side -see Figure 7.
2.) To achieve this, press the snap fasteners at the same time.
To adjust the backrest
1.) There is a wide bar on the bottom side of the lying surface - see Figure #
14.
2.) Pull this upwards to release the snap-in fastening.
3.) The desired position can now be adjusted.
4.) The backrest engages with a clearly audible clicking sound.
Fold down the pushchair
1.) Remove all accessories from the pushchair.
2.) Fold the crossbar backwards.
3.) The surface should be properly aligned in its horizontal position.
4.) Stand at the rear side the pushchair – the hood should be in front of you.
5.) Now, pull the levers provided on either side of the frame towards you - see
Figure # 15.
6.) pram Flash: Please unlock the handle bar safety lock first – see Figure 11
22