Instructions For Assembly - KAPS Flash Bedienungsanleitung

Instructions for assembly

To assemble your pushchair:
1.) Fully remove the pram from the packaging.
2.) Remove all accessories such as the carrying bag, the soft carrier bag or
similar.
3.) Place the City Driver on the axle as shown in Figure 1.
4.) Position yourself in front of the City Driver – the hood and the crossbar
should be located right in front of you.
5.) Put your foot on the brake.
6.) Now, grip the crossbar with both hands and pull it upwards – the pushchair
will unfold – see Figures 2&3.
7.) The pushchair will be fully unfolded and erect once you hear a clear clicking
sound.
To mount the wheels
1.) Make sure both parking brakes are released.
2.) Compress the wheel quick release fastener as shown in Figure #4.
3.) Now, push all four (4) wheels onto the axles until they engage with a clicking
sound – see Figure #5.
To complete the pushchair
To mount the lying surface extension
1.) There is one large snap fastener each on the front of the City Driver on each
end of the frame - see Figure # 6
2.) Use these snap fasteners to attach the lying surface extension and the
retaining bar.
3.) Use the snap fasteners provided on either side to align the footrest – see
Figure # 7.
4.) Hold the lying surface extension in both hands and push the large snap
fasteners into the frame as shown in Figure # 8.
5.) Push the lying surface extension over the snap fasteners – you will hear a
clicking sound as it engages.
6.) Attach the side panels of the lying surface extension to the snap fasteners in
the lining of the pushchair.
To mount the carrier bag
1.) Make sure the lying surface is properly aligned.
20