Operation; Music Control; Microphone Sensitivity - Cameo GOBO Bedienungsanleitung

OPERATION:

STARTUP
Once you have connected the Cameo LED scanner to the power mains, the
motor reset process starts. After approx. 20 seconds, they are recalibrated
and the unit is operational.
Focus the projection by turning the objective ring.
In DMX mode, the focus can additionally be controlled in DMX channel 6.
SELECTING THE DMX START ADDRESS
Press the MODE button and then use the UP and DOWN buttons to select the
DMX start address mode ("ADDR" appears in the display). Now press ENTER
and use the UP and DOWN buttons to select the desired DMX start address
(A001 - A512).
Confirm with ENTER.

MUSIC CONTROL

Press the MODE button and then use the UP and DOWN buttons to select
the music control mode ("SOUN" appears in the display). Now press the
ENTER button and use the UP button to select the master mode (MAST)
or the DOWN button to select the stand-alone mode (ALON) and confirm
with ENTER. The display now reads "SO-M" for master mode or "SO-A" for
stand-alone mode.
In master mode, additional scanners of the same type can be be used on the
master unit as slave units. Select the DMX mode for the slave unit and set
the DMX Start address to 001. Now, using a DMX cable, connect the slave
unit(s) to the master unit (master unit DMX OUT - slave unit DMX IN). Now
the slave unit follows the master unit.
In stand-alone mode, the scanner runs independently of other connected units.

MICROPHONE SENSITIVITY

Press the MODE button and then use the UP and DOWN buttons to set the
microphone sensitivity ("MIC" appears in the display). Press ENTER and use
the UP and DOWN buttons to select the desired sensitivity (M-00 to M-99).
Confirm with ENTER.
9