Connecting The Lcd Tv To A Pc; Using Side Av Connectors; Remote Control Handset; Inserting Batteries - Sharp LC-19LE510E Bedienungsanleitung

Connecting the LCD TV to a PC

For displaying your computer's screen image on your
LCD TV, you can connect your computer to the TV set.
Power off both computer and display before making
any connections. Use 15-pin D-sub display cable to
connect a PC to the LCD TV. When the connection
is made, switch to PC source. See "Input selection"
section. Set the resolution that suits your viewing
requirements. Resolution information can be found
in the appendix parts
PC VGA Cable
(Not supplied)
PC Input
(back)
Side Audio/Video
Connection Cable
(Supplied)
. Side AV Input

Using Side AV Connectors

You can connect a range of optional equipment to your
LCD TV using side connectors of the TV.
• For connecting a camcorder or camera , you should
use AV socket (side). To do this, you must use the
supplied video/audio connection cable. First, plug
single jack of the cable to the TV's AV IN socket
(side). Afterwards, insert your camera cable's (not
supplied) connectors into the plural part of the video/
audio connection cable. Colours of the connected
jacks should match. See illustration below.
• Afterwards, you should switch to
the section Input selection in the following sections
for more information.
• To listen the TV sound from headphones, you
should connect headphones to your TV by using the
HEADPHONE jack as illustrated above..
A01_MB60_[GB]_1910UK_IDTV_TC_PVR_BRONZE17_19942LED_YPBPR_10072629_50186833.indd 13 A01_MB60_[GB]_1910UK_IDTV_TC_PVR_BRONZE17_19942LED_YPBPR_10072629_50186833.indd 13

Inserting Batteries

•
•
Or
Note: Remove the battery from remote control
handset when it is not to be used for a long period.
PC Audio Cable
Otherwise it can be damaged due to any leakage of
(Not supplied)
batteries. Remote range is approximately 7m/23ft.

To Switch the TV On

•
•
•
•
Side AV source. See
Note: If you switch on your TV via CH / CH buttons
on the remote control or on the TV set, the programme
that you were watching last will be reselected.
By either method the TV will switch on.

To Switch the TV Off

•
•
Note: When the TV is switched to standby mode,
standby LED can blink to indicate that features such
as Standby Search, Over Air Download or Timer is
active.
English - 13 -

Remote Control Handset

Remove the battery cover located on the back of
the handset by gently pulling backwards from the
indicated part.
Insert two AAA/R3 or equivalent type batteries
inside. Observe the correct polarity (+/-) when
inserting batteries and replace the battery cover.

Switching On/Off

Connect the power cord to the 220-240V AC 50 Hz.
Then the standby LED lights up.(The led will blink
during the standby On/Off)
To switch on the TV from standby mode either:
Press the " " button, CH / CH
button on the remote control.
Press the " " button, - or + button on the TV. The
TV will then switch on.
Press the " " button on the remote control or press
the " " switch on the TV, so the TV will switch to
standby mode.
To power down the TV completely, unplug the
power cord from the mains socket.
or a numeric
25.07.2011 13:22:29 25.07.2011 13:22:29