INNOCIGS EGRIP 2 SET Bedienungsanleitung Seite 45

INNOCIGS EGRIP 2 – OPERATING AND CHANGING THE DISPLAY MODE
Changing between the VT-Ni, Ti-VT, VT SS316, VW, bypass, TCR mode:
Press the fire button three times in quick succession to enter the menu. The display will indicate
you are in the settings menu by flashing. Press the "up" button to toggle between TEMP (VT), TCR,
POWER (VW) and BYPASS modes. Press the fire button or wait until the display flashes ten times to
confirm the current settings and exit the menu.
1. To select the TEMP or TCR mode, press the "down" button while the display is flashing to enter
the submenus VT, PWR, COIL and AMP.
2. After selecting the POWER or BYPASS mode, press the "down" button while the display is
flashing to enter the submenus VT, PWR, COIL and AMP.
45