System Menu; Parameter Menu - Omnitronic DXO-26 Bedienungsanleitung

System menu

Input option
Switch the stereo link between channels A and B on or off.
Wake-up Time
Via this menu, you can adjust how the controller reacts after turning on.
Fade-in: when turning on, the outputs slowly increase to the preset output volume.
Mute Hold: all output remain muted.
DelayTime/Distance
You can adjust the delay in different units: meters (m) , feet (ft) and milli seconds (ms).
Interface menu
Interface-Setup
Baud-Rate: Here, you can adjust the transmission speed of the RS-232 port. Press the Enter-button.
Remote ID: you can only enter this menu after having confirmed the baud-rate with the Enter-button. Here,
you can adjust the device ID between 1 and 32.

PARAMETER MENU

Press the Gain-button in order to enter the Parameter menu.
Input Gain
Via the jog-wheel, you can adjust the input sensitivity between -40 dB and + 6 dB in 0.5 dB steps.
The display shows if the inputs are linked with each other (e.g. Input A&B). For linked inputs, the gain is
adjusted for both inputs.
Press the Next-button in order to jump to the next parameter.
Output Gain
Via the jog-wheel, you can adjust the output volume between -40 dB and + 6 dB in 0.5 dB steps.
By pressing the Gain-button, you can change to Output 2 etc.
The display shows if the inputs are linked with each other (e.g. OP 1&4). For linked inputs, the parameters
are adjusted for both inputs.
Polarity-function
The polarity of every output can be inverted. If the polarity of a linked output will be inverted, the polarity of
the other channel will also be inverted.
Delay
With the delay, it is possible to compensate differences in the running distances between different speaker-
systems or speaker-systems at different installation spots.
The delay can be adjusted for both inputs and all outputs between 0 and 7 ms in 0.5 ms steps.
How to calculate the delay-time:
The delay-time T equals the distance in meters (D) divided by the speed of sound (C).
T=D/C
How to calculate the speed of sound: C=20.6 * (273 + °C) in meter per second.
Hi pass/Lo pass
Hi pass filter for passing higher frequencies.
Lo pass filter for passing lower frequencies.
21/24 DXO_26_24_V_1_0.DOC
Downloaded from www.Manualslib.com manuals search engine