Operating Procedure; Installation - CombiSteel 7455.1655 Gebrauchsanweisung

3. Operating Procedure

3.1 Check the power and make sure the supply voltage matches the rated voltage.
3.2 Two thermostats are installed at the front panel, they can be used independently or at the same time.
The left thermostat controls the left pasta cooker and the right one controls the right pasta cooker.
3.3 Switch on the device, the green indicator turns on which means the current supply is ready. Rotate the
thermocouple clockwise to the needed position. The yellow indicator turns on which means the heating
tube begins to work and the temperature rises.
3.4 The user can choose the temperature according to different foods and 70-90°C is the ideal temperature
range. It will take 10～15 minutes for the temperature to rise from power on to the water boiling point.
3.5 When the temperature rises to the specified temperature setting, the thermocouple will cut off the
power supply. The yellow indicator turns off, the heating tube stops working and the griddle keeps a
constant temperature. When the temperature drops a little, the thermocouple will connect the power
supply automatically, the heating tube works again and the temperature rises. This action will repeat
during the operations.
3.6 After use, please rotate the thermocouple counter clockwise to original position. And shut off the power
supply for safety.
3.7 The water or soup which is used for boiling the food should be replaced regularly. And the water pan
should be cleaned regularly too.

4. Installation

4.1 The voltage of the power supply has to match the designed power value.
4.2 The user should install an appropriate leakage protection switch near this device.
4.3 There is a copper equipotential terminal on the bottom of the backside which connects with at least
1.5mm² copper wire.
4.4 The installation of this device should be performed by professional technicians.
4.5 Before use, the user should check the power connection to avoid any power cable loosening. And check
if the voltage is normal and well grounded.
4.6 The housing of this device must be grounded well for safety.
4.7 Clean the device before use, shut off the power supply and wipe the device with a wet cloth and
noncorrosive detergent, do not use a water jet for washing this device.
4.8 This device is designed for boiling various of noodles and pasta, any other use is forbidden.
4.9 Before use, the tank must be filled with water, otherwise the heating tube will be burned.
4.10 Before use, the user has to clean all the commercial grease off the water tank, the cleaning procedure
is as below:
1) Top up the water tank with water, boil it for a few minutes. When the temperature rises to
40-50°C, wipe the grease in the tank with a cloth.
2) Do not clean the tank with detergent which includes abrasive material, do not use wire brush/
hard or sharp object to clean the surface of device.
3) After the cleaning, discharge the waste water through the drain, then clean the tank again with
clean water.
4.11 Do not store any flammable or explosive material around the installation. The environment temperature
should be lower than 45℃ and the relative humidity should be lower than 85%.
4.12 This device should be placed at a level position. Keep at least 10 cm distance between this device and
other objects around it. And keep at least a 20 cm distance between the back, wall and window.
www.combisteel.com
4