Description Of Buttons And Led Displays; Self-Test; Operating And Standby Mode - KERN YKN-01 Betriebsanleitung

5 Description of buttons and LED displays

LED display „P"
1
LED display „SEL"
2
3 Button „SEL"
4 Button „LF" Line Feed

5.1 Self-test

You can use the self-test for checking the printer's settings.
To run a self-test, connect the printer to the power supply (LED display „P" lights up
green), keep the „LF" button pressed down and press the „SEL" button at the same
time. A printout showing the data for the self-test will be issued.
Printout example:
RS232
9600bps,
VER.T3.04-150

5.2 Operating and standby mode

When the printer is connected to the power supply, it is automatically in operating
mode and ready for receiving and printing data. It is also possible to switch the
printer to standby mode. To achieve this, press the „SEL" button whereupon the
„SEL" display will go off; the printer is now in standby mode and will no longer
receive data. To return to operating mode, press the „LED" button, whereupon the
„SEL" display lights up again.
Another function of the „SEL" button allows you to introduce a pause. If you press
the „SEL" button briefly while the printer is receiving data, the printer will pause after
having printed out the current line. This pause allows you to operate the line feed.
When you press the „SEL" button again, the printer will continue printing the started
printout.
6
Interface Data transfer by RS232 interface
N,8,1 Baud rate 9600, 8 stop bits, 1 data bit
Version status
Display for power supply
Display for standby mode
Turn on/off standby mode
Start self-test
Line feed
Start self-test
YKN-01-BA-e-1411