Waeco PerfectView Accessory Montage- Und Bedienungsanleitung Seite 27

VT100DIG
Therefore, please observe the following instructions:
 Wherever possible, lay cables inside the vehicle, as they are better protected there
than outside.
If you do need to lay a cable outside the vehicle, ensure that it is well fastened (use
additional cable ties, insulating tape etc.).
 To prevent damage to the cables when laying them, ensure that they are far enough
away from hot or moving vehicle components (exhaust pipes, drive shafts, light sys-
tems, fans, heaters etc.).
 Screw on the plug connections of the connecting cables to protect against water pen-
etration (fig. 4, page 4).
 When laying the cables, make sure:
– they are not kinked or twisted
– they do not rub on edges
– they are not laid in sharp-edged ducts without protection (fig. 3, page 4).
 Protect every through-hole made in the bodywork against water penetration, e.g. by
using a cable with a sealant and by spraying the cable and the cable sleeve with seal-
ant.
NOTE
I
Only start sealing through-holes when you have completed all installation work
on the camera and have laid the required cable lengths.
7.2 Connecting electrical power to the transmitter module
NOTICE!
A
Make sure the polarity is correct.
VT100DIG requires a few seconds to initiate the digital wireless connection. To keep this
start-up time short, you should connect the transmitter module to an active +12 V voltage
supply. If no continuous operating voltage is available, you can connect the transmitter
module to the reversing light.
Connecting the transmitter module to a continuous operating voltage
➤ Connect the red cable of the transmitter module (fig. 6 7, page 5) to an active positive
cable, e.g. terminal 15.
➤ Connect the black cable of the transmitter module (fig. 6 8, page 5) to earth (body-
work).
➤ Connect the green cable of the transmitter module (fig. 6 6, page 5) to the reversing
light.
EN
Connecting electrical power to the radio link
27