Installation With Surface Frame Id Apr-A - OBID classic-pro ID CPR.02.VP/AB-B Montage

®
OBID classic-pro

2.2 Installation with surface frame ID APR-A

1. Wall installation:
• The installation should be executed always on a surface as even as possible.
• Make openings into the bottom part of the casing for lead-in wire, eventually attach twisting
sleeve and pull wire into the casing.
• Screw bottom part of casing to surface.
2. Connection:
see chapter Reader-connection
3. Close casing:
• Snap-in connection board (1) to bottom part of casing according to Fig 3 with the connectors in
downward direction. In order to do this, press the notches slightly apart with your fingers.
• Put top of the casing onto its bottom part. Insert the pin board of the Reader electronic care-
fully into the socket board X3!!
• Screw top of casing to bottom part by using thread cutting screw 3,2 x 25 mm.
• Function test.
4. Adhesive label:
Attach label to clean and non-greasy casing.
Open surface casing with snapped-in connection board (1)
FEIG ELECTRONIC GmbH
+/~ -/~ R COM NO GND R/A T/B
CLK DAT IN1 IN2
(1)
Fig 3: Surface installation (LED top left)
Installation
Page 25 of 36
ID CPR.02.VP/AB-x
M30800-2de-ID-B.doc