Care And Cleaning; Technical Data - Renkforce 1610097 Gebrauchsanweisung

Placing Device into Stand
Always make sure the top plate is securely fastened and the device is firmly held in
place before letting go.
Wall or Ceiling Mounting
When drilling or tightening screws, make sure not to damage any cables, wires or
pipes located underneath the surface. Inadvertently drilling through electric cables
causes the life-threatening danger of an electric shock!
Wall-mounting is permissible only where the wall concerned is of the correct type
and condition. Lightweight partition walls or those made from gypsum boards are
normally unsuitable.
Make sure that the fixing location is sufficiently stable and firm, in order to support
the product and your device.
Check before working, whether the screws and dowels enclosed are suitable for the
relevant wall mounting. If in doubt, contact a specialist before installing the product.
The choice of an unsuitable installation location can lead to personal injury or
material damage!
Prepare the surface for installation. It should be dry, clean, flat and free from debris.
Use a 6 mm diameter drill bit to prepare holes for the dowels.
Do not over tighten screws as this may damage the base plate.
Always make sure the top plate is securely fastened and the device is firmly held in
place before letting go.
You can use the holes on the base plate as a template to mark where to place the
dowels.

Care and Cleaning

• Remove the device from the stand before each cleaning.
• Do not use any aggressive cleaning agents, rubbing alcohol or other chemical solutions as
they can cause damage to the housing and malfunctioning.
• Clean the product with a dry, fibre-free cloth.

Technical Data

Material ......................................... AS (acrylonitrile-styrene copolymer)
Operating/storage conditions ........ 0 to +40 °C, 10 – 90 % relative humidity
Dimensions (Ø x H) ...................... 110 x 40 mm
Weight .......................................... 81 g
This is a publication by Conrad Electronic SE, Klaus-Conrad-Str. 1, D-92240 Hirschau (www.conrad.com). All rights
including translation reserved. Reproduction by any method, e.g. photocopy, microfilming, or the capture in electronic data
processing systems require the prior written approval by the editor. Reprinting, also in part, is prohibited. This publication
represent the technical status at the time of printing.
Copyright 2018 by Conrad Electronic SE. *1610097_v1_0118_02_fl01_m_4L_(2)