ifm PP2000 Bedienungsanleitung Seite 21

Changing stored parameters in the PP2000
Teil 2:
Changing parameters
Part 3:
Storing changed
parameters
4
Mode/Enter Set
Mode/Enter Set
5
6
Mode/Enter Set
Change more parameters:
7
Start again with step 4.
*Decrease the value: Let the display of the parameter value move to the
maximum setting value. Then the cycle starts again at the minimum setting
value.
8
Mode/Enter Set
Mode/Enter Set
9
Mode/Enter Set
10
*A read-only memory with three memory locations is available: nr1, nr2, nr3.
**Cancel:If you do not want to store the data record, wait for 15s.
The unit quits the menu item and displays "SEL" again.
Press the Mode/Enter button
several times until the respective
parameter is displayed.
Press the Set button and keep
it pressed. The current parameter
value flashes for 5s,
then the value is increased*
(incremental by pressing briefly or
scrolling by holding pressed).
Press the Mode/Enter button
briefly (= acknowledgement).
The parameter is displayed again,
the set parameter value is set the
working memory.
Storing parameters:
You can store the parameters at
any time (→ part 3).
Press the Mode/Enter button
several times until the "Sto" is
displayed.
Press the Set button and keep
it pressed.
"nr" flashes for 5s,
then the available memory
locations are displayed one after
the other*
(incremental by pressing briefly or
scrolling by holding pressed).
As soon as the requested memory
location is displayed press the
Mode/Enter button briefly (=
acknowledgement).
"Sto" flashes for a short time.
When "Sto" no longer flashes,
the selected parameters are stored
in the read-only memory.
After 15s "SEL" is indicated.
page 21