Foscam 3.5 ' Pan-Tilt Bedienungsanleitung Seite 13

Using AC Power
1. Plug one end of the provided power adapter into a wall outlet and the other end
into the monitor. See Fig. 5.
Note : Use the adapter labeled OUTPUT: 6V DC with the monitor.
2. Press the POWER button
on. See Fig. 5.
Note 1: When power on the monitor, "Power" LED will light up (green light).
Note 2: "Out of Range" will be displayed on the LCD screen if the monitor
Note 3: Press the POWER button and keep it around 3 seconds to turn off the
2
.2 Monitor Remote Control Function
The monitor can control the movement of the camera. The camera head has the
ability to rotate up, down, right and left. Press the up
on monitor to move the camera up or down. Press the left
on monitor to move the camera left or to the right. See Fig. 6.
2
Zoom in Function
.3
Press the Zoom/OK button
again to change back to normal view. See Fig. 7.
2
.4 VOX ( Voice-Operated Transmission) function
1. Press the VOX button
This will turn OFF the screen but the VOX LED
to remind you the VOX function is enabled. See Fig. 8.
2. When the sound from the camera reaches the setting level (See Fig. 17), the
screen will turn ON automatically. It will turn OFF again after 30 seconds. If
the sound from the camera still reaches the setting level during the 30 seconds,
it will extend 30 seconds to turn OFF the screen from the last voice event.
2
Volume Setting
.5
1. Press the volume setup button
2. Press up
button
2
Talkback Function
.6
Press the talkback button
will then be displayed on the screen. See Fig. 10.
exceeds the range (unlink).
monitor.
or down
to confirm the setting. Fig. 9.
and keep it around 3 seconds to turn the monitor
on monitor once for a 2X zoom of image and press
on the monitor unit to enable the VOX function.
to enter volume setup. See Fig. 9.
buttons to adjust volume level, and then press ok
to speak through the camera unit, and the
or down buttons
or right
will remain ON (green)
buttons
icon
3