Power Connection; Operation; Turning On The Appliance - Kärcher HG 43 Bedienungsanleitung

Power connection

– For connection values, see technical
data and type plate.
– The electrical connections must be
done by an electrician according to IEC
60364-1.

Operation

DANGER
Danger of explosion! Do not spray flamma-
ble liquids.
DANGER
Risk of injury! Never use the appliance
without the spray lance attached. Check
and ensure proper fitting of the spray lance
prior to each use. The screw connection of
the spray lance must be finger-tight.
DANGER
Risk of injury! Hold the hand spray gun and
the spray pipe firmly with both hands.
DANGER
Risk of injury! The trigger must not be
clamped tight during operation.
ATTENTION
Risk of damage! Never operate device with
an empty fuel tank. The fuel pump will oth-
erwise be destroyed.
Replace the nozzle
DANGER
Risk of injury! Switch the appliance off prior
to replacing nozzle and activate hand spray
gun until device is pressureless.
 Secure the trigger gun by pulling out
and engaging the safety latch.
 Replacing the nozzle.

Turning on the Appliance

DANGER
Scalding danger!
DANGER
Follow the safety instructions of the manu-
facturer of the cold water high-pressure
cleaner!
DANGER
The water in the once-through boiler may
contain germs after longer interruptions of
operation lasting several days. Hence,
spray the stale water into the drain for a few
seconds first when using it in the food sec-
tor.
 Switch the power switch of the hot wa-
ter generator to "1/ON".
 Switch on the cold water high-pressure
cleaner as described in the manufactur-
er's operating instructions.
When the amount of water flowing
through is sufficient, the burner will start
automatically.
 Unlock the trigger gun by pushing in
and engaging the safety latch.
When activating the hand spray gun the
cold water high-pressure cleaner switches
on.
 Perform the cleaning operation.
Note: To prevent damage due to too much
pressure, always position high pressure ray
first from a greater distance towards object
to be cleaned.
Turn off the appliance
DANGER
Danger of scalding from hot water! After op-
eration with hot water, the device must be
operated with opened handgun with cold
water for at least two minutes.
 Switch the power switch of the hot wa-
ter generator to "0/OFF".
 Operate the device with opened hand-
gun with cold water for at least two min-
utes.
 Shut off water supply.
 Switch off the cold water high-pressure
cleaner as described in the manufactur-
er's operating instructions.
 Actuate the trigger gun until the cold
water high-pressure cleaner and hot
water generator are depressurised.
 Secure the trigger gun by pulling out
and engaging the safety latch.
– 4
EN
Cleaning
15