Installation And Connection - Phantom Ballast PHB3015 Bedienungsanleitung

INSTRUCTION MANUAL
INSTALLATION AND
CONNECTION
For proper lamp break-in, we recommend that
you run the ballast and bulb at 100% power for
at least 12 straight hours after initial startup.
This will improve lamp life and performance.
1. Find a suitable location for the ballast with
sufficient cooling and away from any heat
source.
2. Install the lamp firmly into the lamp socket
of the reflector and connect the Lock &
Seal lamp cord to the ballast.
3. Remove the power cord from the box. Plug
the power cord into the power input panel
on the side of the ballast.
4. Plug the power cord into the power source
(electrical outlet).
5. Once lamp has fired, set your desired
dimming ratio. Please note that the ballast
dims or raises output gradually to protect
the lamp, so you might not see an instant
increase upon changing your output
percentage.
MOUNTING THE BALLAST
ON THE WALL (FOR REMOTE
OPERATION)
• Remove the mounting screws and wall
mount template from the hardware bag.
• Using the template, mark the mounting
screw positions on the wall. It is
recommended that the screws be mounted
in a wall stud. If that is not possible, please
use drywall anchors rated for at least 15
pounds.
• Install the screws into the stud. Use the end
of the template as a depth gauge to install to
the proper depth.
• Slide the ballast onto the screws.
• We recommend that you mount the ballast
vertically, with the output connector towards
the bottom, for optimal cooling.
DIMMABLE NOTES
• When starting a cool lamp, the ballast
will apply 100% power for 15 minutes to
properly heat the gasses in the lamp. The
dimming feature will not operate during this
initial start-up period, but you can preset
the dimming ratio during this time without
impacting the warm up. After the warm up
is complete, the ballast will run at the set
dimming ratio.
• Press the dimming button to cycle through
the dimming levels (image below). The
appropriate LED indicator will light up to
indicate selected dimming level (60%, 75%,
100%, Super).
• This ballast has built-in hot-restrike
programming to protect the lamp and
ballast in the event of the ballast turning off
unexpectedly. The ballast will not attempt to
restart a hot lamp for at least 15 minutes. If
your lamp fails to start immediately, DO NOT
cycle the power on and off. This can damage
the lamp and ballast. If after 30 minutes
your lamp is still not lit, shut off power to the
ballast, and reconnect. This will begin the
startup sequence again.
• There are three ways to utilize this ballast.
Simply sit it on the floor in a convenient
location; use the holes in the end plate
flanges to hard-mount the ballast into place
with included lag bolts; or hang the ballast
with attached reflector (instructions included
with reflector).
3