baurer BM 60 Gebrauchsanweisung Seite 18

If the battery change
urement is no longer possible and you must replace all the bat-
teries. Once batteries have been removed from the device, the
time must be reset.
The empty, completely flat batteries must be disposed of
through specially designated collection boxes, recycling points
or electronics retailers. You are legally required to dispose of
the batteries.
The codes below are printed on batteries
containing harmful substances:
Pb = Battery contains lead,
Cd = Battery contains cadmium,
Hg = Battery contains mercury.
Setting date and time
• First the year flashes. Using the M2 button, you can increase
the basic values to be set, using M1 you can decrease the
values. Set the year and confirm the entry using the start/
stop button .
• Now set the month using the M1 and M2 buttons.
Confirm using the start/stop button
• Now set the day using the M1 and M2 buttons. Confirm
using the start/stop button
• Now you can set the time, which is displayed in 24-hour
mode. First set the hour, confirm using the start/stop button
and then set the minutes. After confirming with the start/
stop button , the device switches off automatically and the
time is displayed.
is continuously illuminated, meas-
.
.
Operation with the mains part
You can also operate this device with a mains part.
When doing so, there must not be any batteries in the battery
compartment. The mains part can be obtained from special-
ist retailers or from the service address using order number
071.19.
• To prevent possible damage to the device, the blood
pressure monitor must only be used with the mains part
described here.
• Insert the mains part into the connection provided for this
purpose on the right-hand side of the blood pressure moni-
tor. The mains part must only be connected to the mains
voltage that is specified on the type plate.
• Then insert the mains plug of the mains part into the mains
socket.
• After using the blood pressure monitor, unplug the mains
part from the mains socket first and then disconnect it from
the blood pressure monitor. As soon as you unplug the
mains part, the blood pressure monitor loses the date and
time setting but the saved measurements are retained.
• If you are using the blood pressure monitor with the mains
part, position the blood pressure monitor so that you can
easily pull the mains plug from the socket at all times.
18