eKey integra 2.0 Montageanleitung Seite 2

MOUNTING INSTRUCTIONS
In-wall mounting set integra 2.0
General
Description
Item No.
Dimensions (WxHxD) in mm
Flush-mounted housing: 60,50 x 122,50 x 37
Front cover:
Material
Flush-mounted housing: Galvanized metal sheet
Front cover:
4
3
6
RJ 45
5
Design
Finger
element
scanner
Front
cover
ekey In-wall mounting set integra 2.0
101 302 (101 301 incl. LED's)
96 x 142 x 2
Brushed stainless steel
1 7
2
Flush-mounted
housing
These operating instructions are not subject to updating. You can find the most up to date version of these instructions at
Subject to optical and technical modifications, any liability for misprints excluded.
Mounting
Before you start mounting this accessory, you need to make a recess
in the masonry, at a minimum height of 155 cm (height to the lower
edge).
a. Fix the flush-mounted housing (1) into the masonry using the 4
retaining brackets (2).
b. Then fit the finger scanner
c. Proceed with the wiring
d. Place the finger scanner
flush-mounted housing (1).
e. Once you have found the ideal position, fix the finger scanner
using the left and right screws (the upper screw is not needed).
Both self-locking parts turn outwards and both the finger scanner
(3) and the front cover
housing (1).
f. Finally, snap the design element
and then on the bottom side of the finger scanner (see fig. (7)).
LED connection (only for item # 101 301)
When connecting the LEDs, be sure to pay attention to the polar-
BEWARE: LEDs are not convenient for AC operation!
www.ekey.net.
ID 20: Version 4.1, 17.11.2016
(3) into the front cover (4).
(5) (see Wiring instructions).
(3) with the front cover (4) onto the
(4) are thus fixed to the flush-mounted
(6) into place, first on the top side
Supply voltage:12-14 VDC
On state current: 10-20 mA
ity!
(3)