Safety Information - SW-Stahl 32223L Bedienungsanleitung

32223L
Introduction for the Built-in Buzzer
When you press a button Function / Range Switch, the buzzer will sound a beep if the press
is effective. Before the meter turns off automatically. The meter will give several short beeps,
1 minute later it gives a long beep and then turns off automatically.

SAFETY INFORMATION

This meter has been designed according to IEC-81010 concerning electronic measuring
instrument with a measurement category (CAT II 600V) and Pollution degree 2.
WARNING
To avoid possible electric shock or personal injury, follow these guidelines:
• Do not use the meter if it is damaged. Before you use the meter, inspect the case. Pay
particular attention to the insulation surrounding the connectors.
• Inspect the test leads for damaged insulation or exposed metal. Check: the test leads
for continuity. Replace damaged test lead before you use the meter.
• Do not use the meter if it operates abnormally. Protection may be impaired. When in
doubt, have the meter serviced.
• Do not operate the meter around explosive gas, vapour or dusts.
• Do not apply more than the rated voltage, as marked on the meter, between terminals
or between any terminal and earth ground.
• Before use, verify the meter's operation by measuring a known voltage.
• When servicing the meter, use only specified replacement parts.
• Use caution when working with voltage above 30V ac rms, 42V peak, or 60V dc. Such
voltages pose a shock hazard.
• When using the probes or meter, keep your fingers behind the finger guards on the
probes or the meter.
• Connect the common test lead before you connect the live test lead. When you
disconnect test leads, disconnect the live test lead first.
• Remove the test leads from the meter and remove the clamp Jaws from the conductor
under test before opening the case or the battery cover.
• Do not operate the meter with the battery cover or portions of the case removed or
loosened.
• To avoid false readings, which could lead to possible electric shock: or personal injury,
replace the batteries as soon as the low battery indicator
• To avoid electric shock, do not touch any naked conductor with hand or skin.
• Do not hold the meter anywhere beyond the tactile barrier.
• Adhere to local and national safety codes. Individual protective equipment must be
used to prevent shock and arc blast injury where hazardous live conductors are
exposed.
• Remaining endangerment: When an input terminal is connected to dangerous live
potential it is to be noted that this potential at all other terminals can occur!
• CAT 11 - Measurement Category 11 is for measurements performed on circuits directly
connected to low voltage installation. Examples are measurements on household
appliances, portable tools and similar equipments. Do not use the meter for
measurements within Measurement Categories III and IV.
SW-Stahl und Werkzeugvertriebs GmbH
Leverkuser Straße 65
D-42897 Remscheid
Tel. +49 (0) 2191 / 46438-0
Fax +49 (0) 2191 / 46438-40
E-Mail: info@swstahl.de
appears.