Getting Started; First Steps - Red4Power R4-G006S Bedienungsanleitung

4

Getting Started

EN

First Steps

4.1
Open the housing by removing the end cap, on which the USB
plug is located. Carefully plug a 2,5" hard disc onto the SATA
plug. Make sure, that the hard disc is configured as "Master"
(Master is usually default and the instruction is usually on
the housing of the hard disc). Carefully slide the disc into the
housing. Secure the plastic end cap by screwing the included
screws into the holes left and right on the slim side of the
housing.
Connect the unit to your PC using the supplied Y-Cable and
using two free USB ports. At least one of the USB ports
should have a current of 500 mA.
If the hard disc does not get enough power it will often not be
recognized by the system and emit a regular clicking noise. If
you hear this, try using other USB ports or an external HUB
with a separate power supply.
The LED will blink, when the hard disc is addressed. Wait a
moment for your system to recognise the disc and install the
corresponding drivers. Your system will confirm when the
external disc is ready for use.
2 1