Operation - Workers best WB 12 V LI Bedienungsanleitung

Electrical safety
Always check if the battery voltage corresponds to that indicated on the
type plate. Also check if the mains voltage corresponds to the input coltage
of the battery charging device.
Before placing the device in operation
Please read these instructions at all costs before placing your cordless screwdriver into

operation.

• Use only the supplied charging device to charge the battery pack.
• Only use sharp drillpieces as well as faultless and appropriate screwdriver bits.
• When drilling and screwing into walls and brickwork inspect whether they have any
concealed power and gas supply lines and water pipes.
Operation
Charging the battery
The enclosed battery is delivered in a partially charged state
a. To remove the battery (7) push the unlocking button (10) and pull the battery out of
the machine handle.
b. It is only possible to charge the battery in a temperature range of between 0 °C and 40 °C.
c. The voltage indicated on the type plate must coincide with the mains voltage
present.
d. After inserting the battery into the charging device (8) the charging process begins
as soon as there is contact between the battery device and the charging device. Both
the green and the red LED lamps shine permanently. The charging time is approx. 3 to
5 hours when the battery is flat. The green LED shines permanently once the charging
time has been completed.
Note
If the charging of the battery is not possible please check
• whether the power supply is connected to the power outlet.
• whether a perfect contact is present at the charging contacts of the charging device.
To guarantee the long service life of the battery ensure timely recharging. Never
completely discharge the battery. This will lead to the battery being defective!
Adjust the direction of rotation
You can charge the rotational direction with the right/ left rotation switch. This is not
possible if the On/Off switch is pressed.
Clockwise rotation: To drill and screw in screws press the clockwise/anticlockwise
rotation reversing switch to the left as far as it goes.
Counter-clockwise rotation: To detach or unscrew screws press the clockwise/
anticlockwise rotation reversing switch to the right as far as it goes.
BDA WB 12 V LI ABS.indd 20
20
24.05.2011 13:04:45 Uhr