Initial Operation - Oehlbach SCOPE VISION OUTDOOR Bedienungsanleitung

INITIAL OPERATION

The antenna can be supplied with power in two different ways
Variant 1: Operating the antenna via an STB or digital TV (Fig. 3)
1. Secure the antenna in place as described in the mounting section.
2. Connect the IEC connector of the supplied antenna cable to a set-top box or TV.
3. Connect the F-connector of the antenna cable to the antenna itself. The antenna cable can be
shortened to the required length and reattached with the supplied F-connector.
4. Align the antenna to achieve the best signal/image quality.
Variant 2: Operating the antenna via a power supply unit (this method is necessary if your set-top box
or TV does not have a DC output) (Fig. 4)
1. Follow the steps specified for Variant 1 above, but connect the supplied amplifier between the
antenna cable and your set-top box or TV. When doing this, connect the antenna cable to the
"Antenna" input on the amplifier.
2. Then connect the output of the amplifier to the antenna input on your set-top box or TV.
3. Now connect the amplifier to the supplied power supply unit.
BDA_Scope_Vision_Outdoor.indd 11
Fig. 3 Operation via STB or digital TV
Indoor
STB or digital TV
Coaxial cable
Fig. 4 Operation via power supply unit
Indoor
AC adapter (DC 9V)
STB or digital TV
DC IN
Coaxial cable Coaxial cable
Scope Vision Outdoor
Outdoor
Water-drop loop
(recommended)
Outdoor
Water-drop loop
(recommended)
11
23.11.17 13:40