Bluetooth-Setup - G-Lab GENEVA AeroSphère Large Anleitung

II GETTING STARTED WITH THE AEROSPHÈRE SMALL & LARGE
Time required: 5 minutes
Once completed you can play Bluetooth on the AeroSphère speaker
POWERING THE SPEAKER UP
Turn on the AeroSphère speaker
Press the power button on the remote control , or press the power
button at the back of the speaker. The Geneva logo will turn yellow.
Using Bluetooth
Press the button on the remote control, and wait until the entry
"AeroSphère" appears in the Bluetooth setup of your smart phone. For
detailed instructions, go to the next chapter "Bluetooth Setup". With
Bluetooth you can listen music wirelessly without being connected to
your Wi-Fi network.
Proper placement of the AeroSphère Large
The AeroSphère Large is a high performance audio system, and
produces heat during operation. This means the metal plate at the
bottom side can get hot. Do not place the speaker on a heat sensitive
Z\YMHJL  Z\JO HZ \U[YLH[LK ^VVK L[J ;OL Z\YMHJL T\Z[ IL ÅH[
for proper air circulation underneath the unit. The speaker must
not be placed on a bed, sofa or similar surfaces that may block the
natural ventilation.
4
Connect power
Turn the AeroSphère speaker carefully on its side. Don't put the
AeroSphère Large on its head. Connect one end of the power cord to the
connector to the on the bottom of the AeroSphère speaker.
/VSK [OL LUK VM [OL (* WV^LY JVYK [PNO[ ^P[O `V\Y ÄUNLYZ HUK ^PNNSL [OL
connector while pushing in, until it is inserted all the way. Make sure the AC
power cord is properly attached. Finally, plug the other end in a wall outlet.
Remote control
Remove the plastic slip at the end of the remote control.
Now go to chapter "Wi-Fi Setup for AeroSphère Small & Large"
In order to use AirPlay, DLNA or Geneva Multiroom, you need to
connect the AeroSphère speakers to your home network.
BLUETOOTH SETUP
Mobile phones, tablets, and computers with Bluetooth can connect to the AeroSphère speaker and play music wirelessly. The mobile phone,
tablet, or computer must support Bluetooth A2DP. The AeroSphère speaker supports also the high quality codec aptX.
Initial Setup ( "pairing" ) with iPhone, iPad or iPod touch
1. Press on the remote control.
2. Select "Settings" on your iPhone. Select "General / Bluetooth". Turn
on Bluetooth. New Bluetooth devices are detected automatically.
3. Wait until "AeroSphère Small/Large ... ( Not Paired )" appears.
4. Select "AeroSphère...". The phone is now connecting ( "pairing" ) to
the AeroSphère speaker.
5. Once successfully paired, you can play music on an iPhone, iPad or
iPod touch and listen to it on the AeroSphère speaker.
PLAYING MUSIC WITH BLUETOOTH
Most smartphones connect automatically to the AeroSphère speaker
after the initial setup ( "pairing" ).
‹ Press on the remote control. When the AeroSphère speaker
JVUULJ[Z [OL KPZWSH` JOHUNLZ MYVT H ÅHZOPUN IS\L [V H
constant blue color.
‹ Now music that is playing on your smartphone streams
automatically to the AeroSphère speaker.
Status information on the display
Blue, constant: successfully connected.
Blue, fast flashing: searching for previously paired devices.
Blue, slow flashing: pairing / no active connection.
Pairing guide for other devices and mobile phones
Go to www.genevalab.com and select "Support."
ENGLISH
Bluetooth settings on the iPhone ®
Selecting Bluetooth as audio output
( control center of iOS7 )
5