Mali Racing SpeedFighter 2 Anleitung Seite 31

Negative camber on the rear axle reduces the
tendency of the rear of the vehicle to swerve out
in curves.
Adjusting with negative camber causes the con-
tact surface of the tyre to shift inward, increasing
wear on the inner side of
the tyre.
Adjusting the camber on the front and rear
axles
The camber is adjusted using the tensioning
screws (arrows) in the top wishbones.
Turning the tensioning screw clockwise (to the
front) shortens the wishbone, and
the wheel is drawn inward at the top toward
negative camber.
Turning the tensioning screw counter-clockwise
(to the rear) lengthens the wishbone, and the wheel is pressed outward at the top toward positive camber.
Programming of the speed controller
The speed controller is already adjusted to the remote control unit included and the model. When using a new
speed controller or a new transmitter and after reversing the direction of the rotation of the motor by means of
the reverse switch on the transmitter, however, the control range of the accelerator/brake lever has to be reset.
Setting the control range of the accelerator/brake lever
Switch the speed controller off and the transmitter on.
Undo the cotter pins and open the receiver/
controller box..
Press and hold down the set button and
switch on the speed controller.
As soon as the red LED begins to blink, im-
mediately release the set button.
Put the accelerator/brake lever in the neutral
position and press the set button.
The green LED will blink once, and a signal
sound will be heard.
Put the accelerator/brake lever in the full
speed position and press the set button ano-
ther time.
The green LED will blink twice, and the signal
sound will also be heard twice.
Put the accelerator/brake lever in the braked
position and press the set button another
time.
The green LED will blink three times, and the signal sound will also be heard three times.
The adjustment of the control range is now completed, and the motor can be started after 3 more seconds.
!
For more far-reaching programming, follow the separate Operating Instructions for the speed controller.
Download: www.df-models.com
Furthermore, an external module, a programming card, is available in the accessories for user-friendly program-
ming of the speed controller. (No1320)
31