Rio SALON LASER LAHC Bedienungsanleitung Seite 5

© The Dezac Group 2011
Enter the security button sequence by pressing the buttons (highlighted in black) in the following order:
1
© The Dezac Group 2011
If the sequence is entered correctly the unit will emit 2 beeps and the keyswitch will stop flashing and light green. The lowest
power level will light blue and the SCAN and SINGLE buttons will flash blue ready for selection.
Note: The unit will power off if the code is incorrectly entered (the keyswitch will change from flashing green to flashing orange
© The Dezac Group 2011
and the unit will emit two low beeps). Turn the key off, wait a few seconds and then turn the key back on and re-enter the
button sequence.
SE CU RI TY B UTT ON S EQU ENCE
2 3
3 3
4