Learning - Westfalia 96 11 10 Bedienungsanleitung

2. Insert a 12 V battery of the type 23A
into the battery compartment, as shown
in the figure.
3. Replace the rocker on the frame and
check the correct function by pressing
the switch (3) on the upper section. If
the battery is inserted correctly, the
LED lights up green. Now press the
switch on the bottom section and the
LED lights up red.
If you want to mount the switch with
screws and dowels on the wall, first
remove the rocker and than carefully remove the PCB unit (5)
from the cover frame. Insert a small screwdriver into the left or
right oval hole and lift up the PCB unit. Use the fixing oval holes
to mount the frame on the wall. Please note that on the frame
cover, on the PCB unit and on the rocker switch you will find a
positioning symbol (8) and the word "UP". This side has to be up
when mounting the switch.
Otherwise use the delivered adhesive pads to affix the radio
switch at the desired place on the wall. The middle of the switch
should be approx. 1.05 m from the ground and make sure the
LED is situated on the top right side.

Learning

The radio switch serves as transmitter. For using the radio switch
you will need one or several receivers.
The radio controlled lantern, type ED102, Art. 96 11 28 and
the radio controlled halogen floodlight, type EH151, Art. 96 11 36
can be operated with the radio switch. You can operate both
devices simultaneously with this switch or only one device.
Operation
11