Werbung
Verfügbare Sprachen
Verfügbare Sprachen
The camera can transmit on two possible channels. If the metal button is installed at its
backside (see arrow) the camera uses CH2 = 2432 MHz. If the metal button is removed
the camera transmits on CH4 = 2468 MHz.
Take care that the receiver is set to the same channel for receiving signals.
Installation and Connection of the Receiver:
P2008 © Firma WJG, Braunschweig. Nachdruck oder Vervielfältigung nur mit ausdrücklicher Genehmigung
Remove the paper from the monitor holder and attach
it to the monitor by inserting it into the notch on the
backside of the monitor.
Attach the other side of the holder with its vacuum
cup to the desired spot of the inner front shield. Make
sure that the monitor is attached firmly.
Plug the power supply cable to the cigarette lighter of
the vehicle and connect the other side to the
connector of the monitor
Adjust the correct receiving channel with the switch at
the side of the monitor.
Set the ignition lock to ON then the monitor can be
switched on.
A DVD-player can be connected to the monitor
optionally using the audio-/video-cinch connectors.
968-409
Werbung
