Pattfield PA-550ST Bedienungsanleitung Seite 49

Tool can chatter or vibrate if blade speed
is too slow at beginning of cut and possibly
kickback.
h) Always wear safety goggles or eye
protection when using this tool. Use a
dust mask or respirator for applications
which generate dust.
i) Secure material before cutting. Never
hold it in your hand or across legs. Small
or thin material may flex or vibrate with the
blade, causing loss of control.
j) Make certain all adjusting screws and
the blade holder are tight before making
a cut. Loose adjusting screws and holders
can cause the tool or blade to slip and loss
of control may result.
GB
k) When removing the blade from the tool
avoid contact with skin and use proper
protective gloves when grasping the
blade or accessory. Accessories may be
hot after prolonged use.
WARNING!
Some dust created by power sanding,
sawing, grinding, drilling, and other
construction activities contains
chemicals known to cause cancer, birth
defects or other reproductive harm.
Some examples of these chemicals are:
• Lead from lead-based paints,
• Crystalline silica from bricks and cement
and other masonry products, and
• Arsenic and chromium from chemically
treated lumber.
Your risk from these exposures varies,
depending on how often you do this type
of work. To reduce your exposure to these
chemicals: work in a well ventilated area,
and work with approved safety equipment,
such as those dust masks that are specially
designed to filter out microscopic particles.
95
Symbols
Please read all of the safety and
operating instructions carefully
before using this tool. Please pay
particular attention to all sections
of this User Guide that carry
warning symbols and notices.
Observe caution and safety notes!
n
No-load speed.
0
Voltage
V~
Protect electrical power tool from
moisture!
Check that the device, mains lead
and plug are in good condition!
Safety class II
Dispose packaging and appliance
in an environmentally -friendly
way!
GB
96