Use; Conventional Weighing - Vitalmaxx Z 07390 Gebrauchsanleitung

2. The battery compartment is located on the bottom of the scales. The batteries were
secured with a fi lm for transportation purposes. Remove the fi lm to activate the
scales.

Use

CAUTION!
❐ The measurement results which are calculated are only reference values and act
as a guideline. You are explicitly advised against using the results as the basis for
any form of medical treatment or diet! You must consult your doctor if you have any
questions about your weight, a medical treatment or a diet.
❐ Do not stand on the scales with wet feet and make sure that the measuring surface
is dry. You could slip!
❐ The body analysis scales are designed for a maximum body weight of 150 kg! A
higher weight may damage the scales!
❐ Handle the scales carefully as they are a delicate measuring instrument. Do not drop
the device, do not jump on the measuring surface and keep water and other liquids
away from it.
• Weigh yourself without any clothing and barefoot. To make it easier to
compare results, it is advisable to always weigh yourself at the same time
(preferably in the evening, before eating) and under the same circumstances.
• Stand on the contact areas during weighing. The scales can only work
properly if you place yourself correctly on the contact areas.
• Measurement of the body fat and water content as well as muscle and
bone mass is only possible with bare feet. Give the contact areas a wipe if
necessary in order to improve the conductivity. The feet must be dry!
• The scales round up the weight to the nearest 100 g.
• The scales react to a minimum weight of 2 kg.

Conventional Weighing

1. Place the scales on a dry, even, and fi rm base (avoid carpets). Uneven fl oors will
result in inaccurate measurement results.
2. Tap your foot on the scales to activate the display.
3. Wait until the display shows '0.0' (kg / lb / st:lb).
Before you stand on the scales, you can choose whether the weight should
be displayed in kilograms (kg), pounds (lb) or stone (st:lb). You can change
the unit of weight using the  buttons.
4. Stand on the scales. The body weight will be calculated.
5. Once the body weight has been established, the number on the display begins to
fl ash. You can now get off the scales.
6. The scales switch off automatically after a few moments.
17