August EP616 Bedienungsanleitung Seite 5

5.2 Turn On / Off
Press and hold the Power button for 3 seconds to switch on
the EP616. The EP616 will enter reconnection mode and the
status LED will flash red.
Press and hold the Power button for 3 seconds to switch off
the EP616.
If there is no Bluetooth connection, the EP616 will turn off
automatically after 10 minutes.
5.3 Bluetooth Connection
When the EP616 is switched on, it will enter reconnection
mode and connect automatically to any previously known
device. If no previously connected devices are found, the
EP616 will enter pairing mode after 3 seconds.
To connect to a different device, turn off the EP616 first, then
press and hold the Power button for 5 seconds to enter pairing
mode.
In pairing mode, the status LED will flash red and blue.
To forget all previously paired devices, while the EP616 is in
pairing mode, press and hold
seconds.
and together for 6
- 5 -
- For mobile phones and tablets
1. Scan for available Bluetooth devices on your mobile phone
or tablet.
(Please consult the device's user manual for further
instructions if necessary.)
2. Select 'EP616' from the available devices and confirm the
connection. Some devices require a pin code. If this is the
case, please enter the code '0000'.
3. Once successfully connected, the status LED will flash blue.
- For computers
1. Enable the Bluetooth function on your computer.
2. Select 'Device and Printers' from the Control Panel and click
'Add a Device'.
3. Select 'EP616' from the available devices. The computer will
automatically install the driver. If a pin code is requested,
please enter the code '0000'.
4. Once successfully connected, the status LED will flash blue.
5.4 Multipoint
Multipoint allows you to connect your EP616 headphones to
two source devices at the same time.
- To create a multipoint connection:
1. Turn off the EP616 and all source devices.
2. Press and hold the Power button for 5 seconds to turn on
the EP616 and put it into pairing mode. In pairing mode the
status LED will flash red and blue.
3. Press the power button to enable multipoint.
4. Pair the EP616 to the first source device.
5. Turn off the Bluetooth on the first source device.
6. Pair the EP616 to the second source device.
7. Turn on the Bluetooth on the first source device. The EP616
will automatically reconnect to the first source device.
- 6 -