Bosch GRW 11 E PROFESSIONAL Bedienungsanleitung Seite 11

OBJ_BUCH-309-001.book Page 11 Friday, January 19, 2007 8:18 AM
Product Features
The numbering of the product features refers to the
illustration of the machine on the graphics page.
1 Gear selector
2 Auxiliary handle
3 Stirrer paddle adapter
4 Stirrer paddle
5 Drive spindle
6 On/Off switch
7 Lock-on button for On/Off switch
*The accessories illustrated or described are not
included as standard delivery.
Noise/Vibration Information
Measured values determined according to EN 60745.
Typically the A-weighted noise level of the machine is:
sound pressure level 87 dB(A); sound power level
98 dB(A). Uncertainty K=3 dB.
Wear hearing protection!
The typical hand/arm vibration is below 2.5 m/s
The vibration emission level given in
WARNING
this information sheet has been meas-
ured in accordance with a standardised test given in
EN 60745 and may be used to compare one tool with
another.
The vibration emission level will vary because of the
ways in which a power tool can be used and may
increase above the level given in this information sheet.
This could lead to a significant underestimate of expo-
sure when the tool is used regularly in such a way.
Note: To be accurate, an estimation of the level of
exposure to vibration experienced during a given period
of work should also take into account the times when
the tool is switched off and when it is running but not
actually doing the job. This may significantly reduce the
exposure level over the total working period.
Declaration of Conformity
We declare under our sole responsibility that this prod-
uct is in conformity with the following standards or
standardization documents: EN 60745 according to
the provisions of the
98/37/EC.
Dr. Egbert Schneider Dr. Eckerhard Strötgen
Senior Vice President Head of Product
Engineering Certification
30.10.2006, Robert Bosch GmbH, Power Tools Division
D-70745 Leinfelden-Echterdingen
1 609 929 K96 • 19.1.07
2
.
directives 89/336/EEC,
Assembly
Before any work on the machine itself, pull
the mains plug.
Auxiliary Handle
Operate your machine only with the auxiliary
handle 2.
The auxiliary handle 2 can be set to any position for a
secure and low-fatigue working posture.
Turn the bottom part of the auxiliary handle 2 in coun-
terclockwise direction and swivel the auxiliary handle 2
to the desired position. Then retighten the bottom part
of the auxiliary handle 2 by turning in clockwise direc-
tion.
Changing the Tool
Stirrer Paddle with Male Thread, Size M 14
3
4
Screw the stirrer paddle 4 with the adapter 3 onto the
drive spindle 5. Hold the drive spindle 5 in place with
an open-end spanner (size 17 mm) and tighten the
adapter 3 and the stirrer paddle 4 with a second open-
end spanner (size 24 mm).
The stirrer paddle is disassembled in reverse order.
5
English | 11