After Use; Cleaning And Care Of The Unit - Sanitas SHC 40 Gebrauchsanleitung

We recommend the following temperature
settings:
• 150 °C to 180 °C:
- Fine, fragile, coloured or bleached hair
• 180 °C to 200 °C:
- Normal hair
• 200 °C to 230 °C:
- Strong and resistant hair
note
• The higher the selected temperature, the more
quickly you get the desired result.
• If you work with the maximum temperature, do
not work on the same strands more than once.
Straightening/shaping hair
• Dry your hair completely before using the
straightener.
• Your hair should be clean and free of styling
products. Exceptions to this are special pro-
ducts that aid straightening of the hair.
• Comb your hair with a wide-toothed comb to
untangle it.
• Divide your hair into individual strands with
a width of about 3 to 4 cm. Hold the strands
taut and place them between the heating
plates [1] at the roots.

7. Cleaning and care of the unit

notes
• Your unit is maintenance-free.
• Protect the unit from dust, dirt and moisture.
Cleaning
Important
• Always remove the plug from the socket
before cleaning.
• Move the straightener slowly and smoothly
from the roots to the ends. Do not keep the
straightener at any one place for longer than
two seconds. This way you will obtain the
best results without overstraining or damaging
your hair.
• You can shape the ends by twisting the
straightener either outward or inward before
you pull it out over the ends.
note
• Automatic shutoff:
For your safety, the straightener shuts off
automatically after 60 minutes.

after use

• When you have finished the treatment, switch
off the device using the ON/OFF button [4].
• Place the straightener on a non-combustible
surface.
• Remove the plug from the socket after each
use.
• Let the unit cool down.
• Do not wind the mains cable around the unit!
• Store the unit in a dry place that is out of
reach of children.
• Ensure that no water enters the inside of the
unit!
• Do not wash the unit in a dishwasher!
• Do not use any strong, sharp, abrasive, corro-
sive cleaning agents or hard brushes!
• Do not clean it with any highly flammable
liquids!
• The housing of the straightener can be clea-
ned with a soft cloth that has been moistened
with warm water.
12