Driver/Software Installation - Conrad 18 18 18 Bedienungsanleitung

• The "KEYS" connection field allows 5 buttons to be attached, which can also be used to
control the lighting programs, see chapter 8.
• If you wish, connect the IR receiver with the IR connection on the circuitboard. Via this
connection and in connection with the IR remote control, you can control the lighting
programmes, see chapter 9.
• Check all component connections are correct once again.
• Finally, connect the power supply observing the correct polarity with the "+" and "-" terminals
on the controller.
The operating voltage must lie between 12 and 24 V (DC).
Depending on the number of LED strips connected, a current supply of up to 15A is required
(the power required for the three colours R, G, B is additive).
• Directly after you connect the power supply, the device starts the lighting program preset
with the J1-J4 jumpers (see chapter 7); the speed corresponds to that set with the "S-POT"
dial.

The two user programs contain factory preset programs. If you wish to change
these programs you will need to use the PC software supplied and the USB
programming adapter (Conrad order No. 197339).

11. Driver/Software Installation

Minimum operating requirement is Windows XP or Vista/7. Operation with earlier Windows
versions is not possible.
• First install the driver for the USB programming adapter (Conrad order No. 197339).
Observe its operating instructions.
• Then insert the CD included in delivery into the appropriate drive of your computer and install
the controller software.
You require "Microsoft .NET Framework 2.0" to operate the software. This is automatically
installed if it is not currently on your computer.
• After the software installation is complete, an icon for the software appears on your desktop.
• Now connect the computer to the controller using the USB programming adapter, see
chapter 12.
33