Special Safety Instructions; Cleaning And Maintenance; Environmental Information - Power Craft 60219 Gebrauchsanweisung

INSTRUCTION MANUAL

Special safety instructions

Do not switch the polisher on until it is in contact
with the surface to be polished.
Do not apply too much pressure to the surface
being polished.
Avoid applying too much wax or polish to the
application pads, as this can cause them to detach
from the polishing heads.
The polisher must not be used to apply abrasives.
Use
Applying wax/polish
Attach the application pads (5) to the machine's
polishing heads (4).
Apply a thin even layer of wax or polish to the
surface of the application pads. Do not apply wax
or polish directly to the surface to be polished.
Apply the application pads to the item and start
the machine using the on/off switch.
Move the polisher gently over the item in a figure-
of-eight pattern.
Avoid pressing hard on the surface to be polished.
Give the polisher time to work.
Buffing
Remove the application pads and attach the buffer
pads (6) instead. Check that these are completely
clean before starting work.
Apply the buffer pads to the item and start the
machine using the on/off switch.
Buff the item to remove any excess wax or polish.
Buff thoroughly to achieve the best possible final
result.
ENGLISH

Cleaning and maintenance

Wash the buffer pads by hand using a mild soap
solution and hang them up to dry.
Wipe the polisher with a damp cloth if it gets dirty.
Store the machine in an upright position to
prevent the application pads from touching
anything while they dry and reshape.

Environmental information

You can help protect the environment!
Follow local environmental regulations:
Dispose of unwanted electrical
equipment at an approved recycling
station.
12