Hama MW900 Bedienungsanleitung Seite 34

d Bedienungsanleitung
GB
CAUTION
The sensor may be damaged if the alcohol
concentration is too high.
Using alcohol with a high concentration may cause
damage to the sensor.
► Always use alcohol with a concentration of 3-5%.
u To start ASC, press and hold down the BLOW button (7)
and the
beeps twice.
The cleaning process takes approximately 10 minutes.
"ASC" flashes on the display (11) throughout the entire
cleaning process. Remaining time is indicated on the
display as a number between 0 and 10. After the cleaning
process is complete, the device beeps once. As soon as this
happens, switch the device off.
NOTE
►
u
Remove the cleaning cap and blow fresh air several
times into the mouthpiece (1) using the air blower
(included in delivery) in order to
remove any leftover alcohol.
u Start the device's self cleaning process
(see the chapter entitled "Cleaning the
device").
34
button (5) for three seconds, until the device
You can cancel the ASC process at any time by
switching off the device.
MW-900