Live View - Digitus DN-16150 Kurzanleitung Zur Installation

4.3 Live View

Go to "Main Menu" → "Parameter" → "Display" → "Live" to enter the menu as shown below.
4.4 Output
Go to "Main Menu" → "Parameter" → "Display" → "Output" to enter the menu as shown below.
4.5 Record
Go to "Main Menu" → "Parameter" → "Record" → "Record" to enter the menu as shown below.
 Channel: Select channel number.
 Show Time: Tick the checkbox to
display the time.
 Channel Name: Name marked on IP
camera.
Date Format: Set date format such as

mm/dd/yyyy or yyyy/mm/dd.
 Time Format: 12-hour or 24-hour.
 OSD Position: Freely set the position
of IP camera name and time.
Video Output: Live output.

 Seq Mode: Set sequence mode.
 SEQ Dwell Time: Sequence dwell time
is 5 seconds by default. You may set it
as required.
 VGA/HDMI Resolution: VGA output or
HDMI output. Including
1024×768, 1280×1024, 1440×900,
1280×720, 1920×1080
Transparency: Set the transparency of

the menu in the range of 0-128.
 Channel: Set the desired channel in the
drop-down menu.
 Record: Set up the record status
(Enable/Disable) of each channel.
 Stream Mode: Select Mainstream or
Substream.
 PreRecord: "Enable" status supports
pre-record for motion detection record
7