Changing The Bulbs; What To Do In Case Of Malfunctions - Blomberg BDE1200X Bedienungsanleitung

99635821_ML_B.qxd 08/03/2005
C
hanging the bulbs
Caution! Do not damage the seals!
Ensure that both seals are in the right place.
Caution!
The seals must be in perfect condition. In the event that the seals
are damaged, please contact the After Sales Service Department.
W
hat to do in case of malfunctions?
YOU OBSERVE
THAT...
Your display does not light up
The light on the oven cavity
does not work.
Water or steam comes out of
the appliance.
In all circumstances, if your efforts are not sufficient,
contact the After-Sales Service Department without delay.
14:11 Page 27
first turn off the electrical supply
to the appliance.
Turn off the oven and/or acti-
vate the cut-out or unplug the
power lead.
You need to obtain bulbs able to withstand a temperature
of 300°C, 25 watts, 230 - 240 volts, E14, which can be
purchased from shops specialising in electrical items.
1. Turn the cover of the lamp to the left.
2. Turn and unscrew the incandescent lamp in an anti-
clockwise direction.
3. Replace the incandescent lamp.
4. Reinsert the cover, screwing it in a clockwise direction.
POSSIBLE
CAUSES
- Oven is not connected to
power source.
- Electronic board is not func-
tioning.
The light is faulty.
- The door is not properly
closed.
- The door seal has come away
from its support.
- The door seal is faulty.
Before removing the bulbs
from the housing, be sure to
WHAT SHOULD
YOU DO?
- Check that the appliance is
receiving electricity (good fuse).
- Call the After-Sales Service
Department.
Replace the light.
- Close the door properly.
- Correctly insert the seal into its
support.
- Call the After Sales Service
Department.
GB
27