Philips Intellicare GC8080 Bedienungsanleitung Seite 16

ENGLISH
16
Troubleshooting
This chapter summarises the most common problems you could encounter with your iron. Please
read the different sections for more details. If you are unable to solve the problem, please contact the
Philips Customer Care Centre in your country.
Problem
The appliance does not become hot.
Smoke comes out of my new iron
when I switch it on.
The iron does not produce any steam.
Flakes and impurities come out of the
soleplate or the soleplate is dirty.
"Error" has appeared on the display
and the iron beeps continuously.
The appliance produces a pumping
sound.
Dirty water comes out of the
soleplate.
Possible cause(s)
There is a connection problem.
The steam tank has not been switched
on.
The Iron-off function has switched the
soleplate off.
Some parts of the appliance have
been lightly greased in the factory and
may initially give off some smoke when
heated.
There is not enough water in the
water tank.
The steam tank pilot light is still on.
The selected ironing temperature is
too low for steam ironing.
The water tank has not been properly
attached to the steam tank.
When the iron has been set to a very
high temperature, the steam produced
is dry and hardly visible. It will be even
less visible when the ambient
temperature is relatively high and it will
be entirely invisible when the
temperature has been set to MAX.
Impurities or chemicals present in the
water have deposited in the steam
vents and/or on the soleplate.
A sensor failure has been detected.
Water is being pumped into the steam
tank.
The pumping sound does not stop.
Too much scale and minerals have
accumulated inside the steam tank.
Solution
Check the mains cord, the plug and
the wall socket.
Set the on/off switch to 'on'.
Press any button on the iron to
deactivate the Iron-off function.The
soleplate will then start heating up
again.
This phenomenon is perfectly normal
and will cease after a short while.
Fill the water tank (see 'Preparing for
use', section 'Filling the detachable
water tank').
Wait until the pilot light goes out.
Set the temperature to 2 or higher.
Attach the water tank to the steam
tank properly (you will hear a click).
Set the iron to a lower temperature,
e.g. 2, to check if the iron is actually
producing steam.
Clean the soleplate with a damp cloth.
Contact an authorised Philips service
centre.
This is normal.
Unplug the iron immediately and
contact an authorised Philips service
centre.
Rinse the steam tank. See chapter
'Cleaning and maintenance'.