Troubleshooting - iCES ICH-8700 Bedienungsanleitung

TROUBLE SHOOTING：
Problem
The extractor fan ceases
to function.
Insufficient suction power. Did not set to the right
Hood has switched off
during operation.
The lamps do not light up. The lamps are burnt out.
Oil leakage.
Hood shakes during
operation.
Possible cause
The kitchen hood feed
cable is not connected to
the network.
There is no electrical
current in the network.
speed and/or air outlet
being blocked.
The safety cut-out device
has been tripped.
The lamps are loose.
One-way valve and air
ventilation entrance not
tightly sealed.
Leakage from
connection of U-shaped
section and cover.
Leaf is damage.
5
Solution
Connect feed cable to the network.
Check that the
electrical current.
If the kitchen hood is set up for
recirculation, check
charcoal filter is still effective.
If the kitchen hood is set up for
extraction, check that the ducting
and outlets are not blocked.
The kitchen is adequately vented to
allow the entry of fresh air.
Turn off the hood and then wait for
the device to reset.
If the hood has been installed
below the heights indicated in the
installation instructions, the motor
will cut-out frequently which may
damage the hood.
Change the lamps.
Tighten the lamps.
Seal with glue on the one-way
valve.
the Seal with soap
U-shaped section.
Replace the leaf as a damaged leaf
causes shaking.
Lock the motor tightly or fix the
network has
that the
or paint on