Team DAI 7 Gebrauchsanleitung Seite 9

Fax +32 2 359 95 50

FILLING THE WATER TANK
Use preferably demineralised water. If you want to use the steam dial, fill the water tank as
follows:
1) Unplug the iron from the outlet to let it cool down and set it horizontally on a stable level
surface.
2) Put the temperature dial to "MIN" and the variable steam dial to the 0 setting.
3) To fill the water tank, open the lid of the filling opening and pour water using a measuring
cup. Never exceed the MAX mark indicated on the appliance.
4) When ironing, unplug the appliance before refilling. Fill the water tank by holding the
appliance in horizontal position without putting down the hot soleplate, unless you have a
heat-resistant base.
TEMPERATURE SETTINGS
 You can choose the temperature setting in function with the cloth to iron.
 Plug in the iron. Choose the correct ironing temperature by turning the fabric selector switch
(7). The temperature indicator lights up. Once the desired temperature has been reached,
the temperature indicator lamp will go out.
DRY PRESSING
 Put the variable steam dial on position 0.
 Plug in the iron.
 Set the temperature dial for the desired fabric. Always check the label of the garment
before choosing the temperature setting.
Set iron on heel rest and wait until temperature indicator light goes out.

STEAM PRESSING
Kind of textile
Synthetic (e.g. acetate,
acrylic, viscose, polyamide,
polyester, ...)
Silk
Wool
Cotton
Linen
Cleaning
 Fill the water tank (variable steam dial on 0 position).
 Put the plug of the appliance into the power socket.
 Choose the desired temperature.
 Put the variable steam dial between 0 and 4 according to the desired amount of steam.
 Set the iron on its heel and wait until the temperature indicator goes out.
Caution: Set the temperature dial within the steam range. If the temperature setting is too low,
water may drip from the soleplate.
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International BELGIUM. The pages must be reproduced
and folded in order to obtain a booklet A5 (+/- 148.5 mm
width x 210 mm height). When folding, make sure you
keep the good numbering when you turn the pages of
the I/B. Don‟t change the page numbering. Keep the
language integrity.
Temperature dial
MIN
|
|
|
|
|
|
MAX
|
MAX
|
9
Assembly page 9/36
Steam ironing
0
1 - 2
3 - 4
TEAM DAI 7 - 090210