Care And Cleaning - Team dai 27 Gebrauchsanleitung

Fax +32 2 359 95 50


Turn on the iron.

Turn the temperature dial clockwise into the required position.

Turn variable steam/dry dial on (1) for minimum steam or on the positions (2) or
amount of steam.

Set the iron on its heel and wait until the temperature indicator goes out.
! Set the temperature dial within the steam range. If temperature setting is too low, water may drip
from soleplate.
! Check the garment label before ironing because some coths may be damaged when exposed to
steam or water.
SPRAY

Produces a mist for removing stubborn creases.

Spray can be used at any temperature setting and during either dry or steam pressing. Press down
the spray button to spray.
! Be sure to check the garment label for care instructions. Some fabrics may be damaged when exposed
to steam or water.
STEAMJET
The steamjet feature provides additional steam for removing stubborn creases.

CARE AND CLEANING


Cleaning the inside parts of the iron is done by turning the steam/dry dial into the

position and holding the iron horizontaly for about one minute so steam can escape.

When you turn the variable steam/dry dial into the
take it out.

There is no problem. YOU JUST HAVE TO PUT IT BACK IN ITS PROPER PLACE BEFORE
EACH USE. Therefore just keep it deep (in the good position) and turn it clockwise.
WHEN YOU HAVE FINISHED IRONING

Turn temperature dial to "MIN" and unplug iron from electrical outlet.

With soleplate facing away from you, turn iron upside down to empty water.

Then store the hot iron on its heel rest so that any remaining moisture will evaporate.
Generated by Unregistered Batch DOC TO PDF Converter
2011.3.804.1511, please register!
Copies of the I/B. Please reproduce them without any changes
except under special instruction from Team International
BELGIUM. The page must reproduced and folded in order to
obtain a mini booklet B5 (+/- 150 mm width x 210 mm height).
The page must be folded in order to keep the good numbering
when you turn the page of the I/B . Don‟t change the page
numbering. Keep the languages integrity.
Assembly page 10/34
, this goes up a little bit and you can
10
(3)
for a larger