Eureka MIGNON PERFETTO Gebrauchsanweisungen Seite 25

EN
6.5 FILTER HOLDER FORK ADJUSTMENT
• Insert the filter holder fork (6) into its seat (Fig. 6).
• With a screwdriver, loosen the fixing screw of the filter holder fork (6).
Do not loosen the screw completely.
• Lift or lower the fork to adjust it according to the filter holder dimensions (Fig. 7).
• Once having found the correct position, tighten the fork fixing screw (6).
• The fork is suitable for any kind of filter holder available on the market.
6.6 MACHINE PROGRAMMING
(PERFETTO - SPECIALITA' - MAGNIFICO)
6.6.1 TURNING THE MACHINE ON
When starting the machine for the first time, the appliance has the factory default
settings. In the subsequent starts, it keeps the settings preceding the last turning off.
When starting, the display loads the firmware and gets ready for dispensing.
6.6.2 DOSE DISPENSING AND ADJUSTMENT (DISPLAY)
• By pressing the button of one dose (16)
dispensed is selected (the buttons goes on).
• With a single pressure (quick) of the grinding start button (5), the coffee dispensing and
the countdown to zero are activated.
• When the dispensing is complete, the grinding time goes back to the value set.
• The counter of single or double doses is increased by 1.
• Select the single (16)
and (15) to increase or reduce the dispensing time of the selected dose (the time is
shown in seconds on the display).
• If the button (14)
increased or reduced according to the pressure time.
To pause the automatic dispensing before the grinding time has elapsed, press the
grinding start button (5) with the filter holder:
• Press the button (5) again to restart the dispensing for the remaining time.
• Keep pressed the button of the selected dose (blinking) to stop dispensing. The
grinding time goes back to the value set.
6.6.3 CONTINUOUS DISPENSING
Press the single dose (16)
access this mode. The symbol (13)
Press the grinding start button (5) to enable the continuous dispensing and press it once
more to stop. The continuous dispensing lasts up to max. 60 seconds.
To exit the continuous dispensing mode, keep pressed the single dose (16)
double dose (17)
or double dose (17)
or (15) is kept pressed for some seconds, the time is
and double dose (17)
appears on the display.
button for some seconds.
or double dose (17)
and press the buttons (14)
buttons at the same time to
, the dose to be
or the
11