Operation - RUSTA Boat race Gebrauchsanweisung

ENG
PREPARATION
1. Insert the antennas at the top of the transmitters. Tighten it.
2. Insert 4 x 1,5V AA batteries (not included) with the correct polarity into the battery
compartment of the transmitters. Replace the cover.
3. Open the air inlet of the pool and inflate it by using the pedal pump to pump air into the
pool. Tightly cover the air inlet once finished.
CHARGING
1. Pull the ON/OFF switch of the transmitter to ON.
2. Open the charging cover beside the transmitter and take out the charging plug. Insert
the charging plug into the charging port of the boats.
3. The charging indicator will illuminate to indicate that charging is in process.
4. When the indicator turns off, the charging process is finished.
5. When fully charged, playing time is approx. 8 minutes.

OPERATION

• Pull the antenna of the transmitter out till maximum. Switch the power of the trans-
mitter on and put the boats into water. Do not touch the propellers and make sure that
there are no obstacles around the propellers.
FUNCTIONS OF THE TRANSMITTER
• If you press any controllers on the transmitter, an indicator light will illuminate.
• When pressing the forward/backwards button on the right hand side, the boat will
move forward/backwards.
• When pressing the forward button and also pressing the left/right turn button on the
left hand side, the boat will turn left/right.
• Above the propeller of the boat, a direction guide is placed. By adjusting it, you can
adjust the driving performance and let it run in a straight line.
TIPS!
If the boats are being used under abnormal operation or carelessly, water may get into
the inner body and stop the boat form functioning correctly. If this happens, use a screw-
driver to loosen the 4 screws located on the top of the boat. Turn the screws anti-clock-
wise. Slightly separate the boat body from its deck and leave to dry. Once it has dried
completely, screw the boat back together.
4