Schartec R5111 Anleitung Seite 2

Models: R5111/R5113 /R5114/R5115/R5117/R5110/R5112/ (R5111V5)
Schartec
a trademark by bau-shop-24 GmbH
Fritz-Müller-Strasse 115
73730 Esslingen
I. Safety Instructions
1.
Please read this manual before installation and use.
2.
Please delete memory before first use (See 4.2)
3.
To prevent accidental operation of door drive, not attempt to code in the remote control while the door drive is
moving / in use.
4.
The signal may be interfered with by other radio devices in the environment (e.g. babyphones or the like that have the
same frequency). Therefore, this product must not be used with high-risk devices (e.g. cranes or the like).
5.
Keep remote controls out of reach of children.
6.
The remote control should only be used when in visual sight of the door / gate.
7.
Remote controls should only be used by persons who have been properly instructed in it's use.
8.
Protect the remote and receiver from rain, snow, direct sunlight, as well as dust.
9.
The receiver is intended for dry rooms only.
10.
Interferences may occur, if the receiver is placed too close to the door operator control board.
11.
Function of the radio receiver may be impaired if the connection cables are too long.
II. Technical Data
1. Power Supply: 12-24VAC/DC
2. Working Temperature: -20°C - +60°C
3. Frequency: 433.92 MHz
4. Coding: Rolling-Code
5. Memory: up to 500 remotes
III. Connections
1. 12-24 V AC/DC = Power Supply (left + / right -)
2. NO1 + COM1 = Output 1 (Channel 1)
3. NO2 + COM2 = Output 2 (Channel 2
IV.
Programming
4.1 Coding in the remote control: Press the "Learning Button", the LED lights up red. Press one of the remote buttons twice,
the LED flickers, then illuminates again, then goes off. This means the learning process is finished. Button 1 operates Channel
1 / Button 2 operates Channel 2.
4.2 Deleting a remote: Press and hold the "Learning Button", the LED lights up red. After approx. 8 seconds, the LED turns
green, then release the "Learning Button". The LED now lights red briefly and then turns green again. The deletion process is
now complete.
4.3 Transmit code from remote to remote (only possible with 4-button remote): As soon as a remote has been taught to the
receiver, the code can also be transmitted from this remote to the other remotes without having to press the learning button
on the receiver. Press "Button 1" and "Button 2" of the old remote once, the programming mode is now active. Press and hold
down the "2" button on the old remote and press the desired button of the new remote 2 times in succession. The code has
now been transferred.
Version A1
Instruction Manual
2-Channel Receiver