Connect And Set Up - MAC Audio SOUNDBAR 2000 Bedienungsanleitung

CONNECT AND SET UP

This section helps you connect your Soundbar
to a TV and other devices, and then set it up.
Note
• For identification and supply ratings, see
the type plate at the back or bottom of the
product.
• Before you make or change any connections,
make sure that all devices are disconnected
from the power outlet.
Position the Soundbar
Place the subwoofer at least 1 meter away
from your Soundbar, and ten centimeters away
from the wall.
For best results, place your subwoofer as
shown below.
Wall mount the Soundbar (optional)
Screw length/diameter
Depending on the type of wall for mounting
your Soundbar, make sure that you use screws
of a suitable length and diameter.
1. Drill two holes on the wall (distance 50 cm).
2. Secure the dowels and screws in the holes.
3. Mount the wall bracket (L-profile) to the
bottom of the soundbar. Use the supplied
M4 screws to fix the wall brackets to the
soundbar.
4. Hang the Soundbar on the fastening screws.
Warning
• Improper wall mounting may result in
accident, injury or damage. If you have
any query, contact Consumer Care in your
country.
• Before wall mounting, make sure the wall
can support the weight of your Soundbar.
• Mac Audio is not liable for improper wall
mounting that results in accident, injury or
damage.
• Install the Soundbar on a sturdy vertical
wall.
• Do not install the Soundbar onto a ceiling or
slanted wall. It may fall down and result in
severe injury.
• Do not use screws that are shorter than the
specified length, otherwise the Soundbar
might fall down.
• Do not mount the Soundbar on a wall while
the Soundbar is plugged in or turned on, it
may result in an electrical shock injury.
18