Operation; Control Panel Operation; Menu Map; Configuration (Dmx) - Chauvet Swarm 5 FX Bedienungsanleitung

4. O
PERATION
This product is not designed for continual use. Make sure there are regular breaks during operation to maximize the life
of your laser. Always disconnect the Swarm™ 5 FX from power when not in use.
Control Panel

Operation

Menu Map

Mode
DMX Mode
Automatic Mode
Sound-Active Mode
Slave Mode
Configuration
(DMX)

Starting Address

Swarm™ 5 FX User Manual Rev. 4
To access the control panel functions, use the four buttons located underneath the display.
When the product is on, the LED monitor on the rear panel will show the current operating mode
(Standalone or DMX). The product will retain the last saved settings when powered off.
Button
<MENU>
Selects an operation mode or backs out of the current menu option
<UP> Scrolls up the list of options or selects a higher value
<DOWN> Scrolls down the list of options or selects a lower value
<ENTER> Activates a menu option or a selected value
Programming Steps
d001—d506
AUT0—AUT6
SOU0—SOU6
SLA
Set the product in DMX mode to control with a DMX controller. The product uses 3-pin DMX
cable.
1. Connect the product to a suitable power outlet.
2. Connect a DMX cable from the DMX output of the DMX controller to the DMX input socket
on the product.
When selecting a DMX starting address, always consider the number of DMX channels used by
the fixture. If you choose a starting address that is too high, you could restrict the access to
some of the product's channels.
The Swarm™ 5 FX uses 9 DMX channels, which means the highest DMX address you can use
is 504.
If you are not familiar with the DMX protocol, download the DMX Primer from
http://www.chauvetlighting.com/downloads/DMX_Primer_Rev6_WO.pdf.
To select the starting DMX address, do the following:
1. Press <MENU> repeatedly until d001–d506 blinks on the display and the DMX light come
on.
2. Use <UP> or <DOWN> to select the starting address.
3. Press <ENTER> to put the fixture in DMX mode. The display will continue to blink.
The display will continue to blink until the fixture receives a DMX signal.
Function
Description
Selects the DMX starting address
S 1—S100 Selects auto program and speed
Sound-Active modes
Slave mode
Page 19 of 108