Getting Started - Bellman BE2020 Bedienungsanleitung

30
Bellman Audio Maxi Digital Communication Aid, BE2020
Thank you for choosing products from Bellman & Symfon.
Bellman Audio is an assistive listening system. The system consists of a number of units which
facilitate listening under different circumstances. Bellman Audio products make everyday life
easier for many people and give them the freedom to freely pursue their interests.
Read through the entire user manual first before starting to use the product.
Refer to the diagram showing the accessories and connection options on the inside of the cover.

Getting started

Unpacking, installing and testing the unit
1. Open the battery cover (17) by pressing the battery cover lock (16) in the direction of the
arrow. Fit the batteries and make sure they have been inserted the right way round. Follow
the markings in the battery compartment (14). Only use AA alkaline type batteries. Do not
use force to press down the batteries. Close the battery cover (17) and check that the lock
(16) locks with a click.
2. Connect BE9122 Bellman Headphones, BE9128 Bellman Neck Loop, BE9125 Bellman
Stetoclip, BE9124 Bellman Ear Phones or another product recommended by Bellman &
Symfon to the green headphone output (12) on the right-hand side.
3. Give one short press on the On/Off button h (5) to start Maxi. The LEDs (3 and 4) above
the Microphone selection button a (6) and the Telecoil selection button d (7) will blink
while Maxi starts.
4. Maxi always starts with the internal microphone (2) selected as a sound source. In addition,
the volume control is always set to low volume to avoid unpleasant sound levels.
5. Use the volume control bc (9) to control the sound level. c increases and b reduces the
volume. The Volume and Tone LED Indicator (8) shows the sound level. The more LEDs
that are lit the higher the volume. The LED indicator goes out 3 seconds after the sound
volume has been set.
6. Use the tone control fg (10) to adjust the sound quality. g increases and f reduces the
treble. The Volume and Tone LED Indicator (8) shows the tone setting. The LED indicator
goes out 3 seconds after the sound quality has been set.
7. When you have finished, you can switch off Maxi by giving a short press on the On/Off
button h (5).
Function
The BE2020 Bellman Audio Maxi Digital Communication Aid is a digital amplifier which has
been specifically developed to provide an exceptional sound experience even in demanding
situations. Maxi works extremely well for speech and music with the built-in microphone, with an
external microphone (accessory) or with other external sound sources.
Built-in microphone
The built-in microphone (2) is located under the rubber cap on the top of the front panel.
The microphone is an omnidirectional one.